Drill Doctor - Drill Doctor 750X FAQs

Home FAQs 750X FAQsDrill Doctor 750X FAQs

Drill Doctor 750X FAQs

items
After I split my drill, there is too much material being removed.
Are parts available for my machine?
Do I rotate my chuck to put the split tip on the drill.
How do I secure the bit properly into the chuck?
I don't see the split port on my machine?
I have a set of parabolic bits, if I follow the alignment directions, the point still comes out different. Is there a different direction I need to take this?
I have an older DD750SP that has 2 chucks. Why does the new design only come with the one?
I'm getting negative relief.
I'm sharpening at 135 degrees and the point is not coming out right, what am I doing wrong?
My drill bit will not touch the wheel when I go to sharpen.
My machine only came with one chuck. The case has slots for 2.
My point angle plates moves when I sharpen?
When should I use the M.T.O. Knob?
Why would I need to put a split on my drill?