Drill Doctor - Drill Doctor 500X FAQs

Home FAQs 500X FAQsDrill Doctor 500X FAQs

Drill Doctor 500X FAQs

items
After I split my drill, there is too much material being removed.
Are parts available for my machine?
Can I adjust the point angle on the DD500X
Can I sharpen past a 1/2 inch?
Do I rotate my chuck to put the split tip on the drill.
How do I secure the bit properly into the chuck?
I don't see the split port on my machine?
I have a set of parabolic bits, if I follow the alignment directions, the point still comes out different. Is there a different direction I need to take this?
I'm getting negative relief.
I'm sharpening at 135 degrees and the point is not coming out right, what am I doing wrong?
My drill bit will not touch the wheel when I go to sharpen.
My point angle plates moves when I sharpen?
Why would I need to put a split on my drill?