My drill bit will not touch the wheel when I go to sharpen.
There can be several things that can cause this. One, the sharpening tube is not installed properly. Look up by the cam pin and see if there is a gap. If so then, re install the sharpening tube so it is back in its original position. This could have been caused if the point angle plate was shifted from 118 to 135. Also, make sure that the the bit touched the drill stop in the alignment port and the clamps have grasped onto the narrowest part of the drill, be sure to tighten the bit securely while in the alignment port before removing it. This will ensure that the the bit is locked into position and will not "back out."